LOKLiK iCraft™ Deep-point Blade - 2 Pack

The iCraft™ deep-point blade pack contains 2 replacement blades. With a cutting angle of 60°, these blades can be used on heavyweight materials, such as faux leather, PVC template magnetic sheets, EVA foam board,... Whether you're cutting intricate details or working with different materials, these cutting blades offer the precision you need.

Please note:

• These blades are not compatible with the LOKLiK Crafter cutting machine.
• These iCraft deep-point blades use a different blade holder than the fine-point blades. Check out the deep-point blade kit if you need a holder too.

These blades can be used for cutting: 

• Faux leather
• Shrink plastic sheets
• PVC template
• EVA foam board
• Magnetic sheets
• …

 How to install a new cutting blade in your LOKLiK iCraft™:

1. Power off the machine: Ensure the cutting machine is fully powered off before beginning the blade replacement.
2. Remove the old blade: Carefully open the blade holder by unscrewing it and remove the old blade.
3. Insert the new cutting blade: Take a new deep-point blade from the package and place it into the blade holder with the sharp side facing down.
4. Secure the blade holder: Screw the blade holder back into place to secure the new blade.
5. Test the blade: Power on the machine and perform a test cut on a scrap piece of material to ensure the blade is properly installed and functioning as expected.

Care and Maintenance

Store unused blades in a dry and safe place to prevent rust and damage. Regularly cleaning your cutting blade and holder can extend the blade's lifespan.